Hard Drive - HP 17-u199 Maintenance And Service Manual

Hard drive

Description
1-TB, 5400-rpm, SATA, 7.2-mm hard drive
NOTE: The hard drive spare part kit does not include the hard drive rubber bracket or hard drive cable.
The hard drive rubber bracket is available using spare part number 857826-001. The hard drive cable is
available using spare part number 857835-001.
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the hard drive:
1. Release the zero insertion force (ZIF) connector (1) to which the hard drive cable is connected, and then
disconnect the hard drive cable (2) from the system board.
2. Lift the right side of the hard drive (3) until it rests at an angle.
3. Remove the hard drive (4).
4. If it is necessary to replace the hard drive cable, disconnect the cable (1) from the hard drive.
Bottom cover on page 26).
Spare part number
766457-856
Battery on page 28).
Component replacement procedures 33