Table of Contents
Advertisement
Solid-state drive
Description
512-GB, M2, SATA-3 solid-state drive supporting TLC
256-GB, M2, SATA-3 solid-state drive supporting TLC
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1.
Remove the Phillips M2.0×3.7 screw (1) that secures the solid-state drive to the computer. (The solid-
state drive tilts up.)
2.
Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Bottom cover on page
26).
Spare part number
857899-001
857898-001
Battery on page
28).
Component replacement procedures
29
Advertisement
Table of Contents
