HP 17-u199 Maintenance And Service Manual page 35

4. Remove the following screws that secure the bottom cover to the computer:
(2) Four Torx5 M2.0×11.9 screws
(3) Seven Torx5 M2.0×5.8 screws
5. Insert a case utility tool (1) or similar plastic, flat-edged tool between the bottom cover
and the computer near the display hinge areas.
6. Release the bottom cover rear edge (2) and swing it up and forward until it releases.
7. Remove the bottom cover (3).
Reverse this procedure to install the bottom cover.
Component replacement procedures 27