WIRING DIAGRAM FOR MAGIS PRO V2 INDOOR UNIT
WITH OPTIONAL SECOND ZONE KIT IN CONTAINER
SUPER TRIO.
8
1
2
6
5
10
8
25
Once the kit is assembled, proceed with the
wiring according to the wiring diagram in the
instruction booklet.
- Connect the cables in the control panel of the
Magis Pro V2 Indoor Unit as shown in Fig. 10.
- Lower the wiring exiting the Magis Pro V2 In-
door Unit until it can be secured with the clips
(1-2).
- Connect the flow probe connector (10) to the
wiring marked by the label "PROBE", then
connect the wiring to the probe and connect
the "T-SIC" connector to the safety thermostat.
- Connect the connector with the green "M-Z2"
label to the circulator (8).
- Connect the connector of the mixing valve (6)
marked with the "MIX.V" label.
- Now group the various cables and join them
with the clip (5) supplied with the hydraulic
manifold.
N.B.: wind the uncovered fittings with the
insulation present in the kit.