WIRING DIAGRAM FOR MAGIS COMBO PLUS V2
INDOOR UNIT WITH OPTIONAL SECOND ZONE KIT
IN SOLAR CONTAINER COMBO.
7
1
2
6
7
11
9
24
Once the kit is assembled, proceed with the
wiring according to the wiring diagram in the
instruction booklet
.
- Connect the cables in the control panel of the
Magis Combo Plus V2 Indoor Unit as shown
in Fig. 11.
- Lower the wiring exiting the Magis Combo Plus
V2 Indoor Unit until it can be secured with the
clips (1-2).
- Connect the flow probe connector (11) to the
wiring marked by the label "PROBE", then
connect the wiring to the probe and then
connect the "T-SIC" connector to the safety
thermostat.
- Connect the connector with the green "M-Z2"
label to the circulator (9).
- Connect the connector of the mixing valve (7)
marked with the "MIX.V" label.
- Now group the various cables and join them
with the clip (6) supplied with the hydraulic
manifold.
N.B.: wind the uncovered fittings with the
insulation present in the kit.