Chapter 6: Commissioning The Installation; Removing The Inverter Cover - SolarEdge StorEdge SE7600A-USS Installation Manual

Chapter 6: Commissioning the Installation

Chapter 6: Commissioning the Installation
This chapter describes how to activate the system, pair the power optimizers to the inverter and verify
the proper functioning of the system.

Removing the Inverter Cover

If the inverter cover is not already removed, use the following procedure for cover removal for
communication connection or maintenance purposes.
1. Turn the StorEdge Connection Unit to OFF.
2. Turn the inverter ON/OFF switch to OFF.
3. Disconnect the AC to the inverter by turning OFF the circuit breakers on the distribution panel. Wait
5 minutes for the capacitors to discharge.
4. Open the inverter cover's six Allen screws and carefully pull the cover horizontally before lowering it.
CAUTION!
When removing the cover, make sure not to damage internal components. SolarEdge will not be held
responsible for any components damaged as a result of incautious cover removal.
Lors du retrait du couvercle, assurez-vous de ne pas endommager les composants internes. SolarEdge
ne peut être tenue pour responsable des composants endommagés à la suite d'une imprudence dans le
retrait du couvercle.
44
SolarEdge StorEdge Installation Guide MAN-01-000262-1.2