Table of Contents
Advertisement
Authentication Password
SIP password provided by the system administrator for the SIP account used for the
associated Ring and/or Page parameter.
Extension to Dial
Phone number to be dialed when the Call button on the door station is pressed.
Basic Settings Tab – Features
Ring/Alert Tone
Select WAV file to play when a ring event is detected on the SIP Ring extension. The
WAV file may be played immediately to the speaker from the web interface for test
purposes using the Play, Loop, and Stop buttons.
Note: This is the "Default" tone that will be played if selected for Multicast,
Additional Ring Extension settings.
Ring/Alert Volume
Set speaker volume for SIP ring event. This setting is an amplifier gain control and the
output level will also depend on the levels recorded into the source WAV file played from
memory. This setting is only used for local tones, and not when receiving multicast (see
Page Speaker Volume below).
Ring Limit
Typically set to no limit, this feature can be used to set a limit on how long the speaker will
ring before timing out. A new ring event is required before the speaker will play the WAV
file again.
Page Speaker Volume
Speaker page volume control for SIP or multicast paging. This setting is an amplifier gain
control and output level will depend on streaming level. This setting will apply to all
multicast, regardless of content.
Page Mode
A call to the SIP page extension can be one-way, two-way using the integrated
microphone, or delayed. In delay mode, the speaker will store the page into memory and
then play after disconnect.
In delay mode, press "*" to cancel a page while the recording state is in process to prevent
it from being sent after hanging up.
Page Timeout
A time limit may be set for an active page.
Document 90-00097A
05/22/2019
Page 20
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8190 SIP Classroom Speaker FW 1.7.3
(604) 454-3792
support@algosolutions.com
Advertisement
Table of Contents
