Wall Mounting; Programming And Configuration - Algo 8190 User Manual

Wall Mounting

Mount the wall bracket securely. Once the wall bracket is secure, slides the 8190 onto the
bracket. Secure the 8190 to the wall bracket with the provided four screws.

Programming and Configuration

After connecting the 8190 to a network PoE, the blue indicator light at the top will turn on
during initialization. The 8190 will then attempt to obtain an IP address from the DHCP
server. If there is no DHCP server or the attempt was unsuccessful, the 8190 will default
to the static IP address 192.168.1.111.
Note: If you don't have a PoE switch, you'll need a PoE or PoE+ injector installed
between the 8190 and the network switch. The PoE injector will supply 48 Vdc to
the 8190. Most PoE injectors are capable of providing more power than the 8190
requires (12.95 W). Ensure that the PoE injector is fully compliant to the IEEE
802.3at PoE+ or 802.3af standard.
After a successful boot up the blue LED will turn off and you will hear a tone, and the
speaker will have obtained an IP address.
Press the reset button button (RST) momentarily to hear the IP address over the speaker
and press it again to stop playing the IP address over the speaker.
The IP address may also be discovered by downloading the Algo locator tool to find Algo
devices on your network:
Document 90-00097A
05/22/2019
Page 10
www.algosolutions.com/locator
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8190 SIP Classroom Speaker FW 1.7.3
(604) 454-3792
support@algosolutions.com