Table of Contents
Advertisement
TouchPad button board
Description
TouchPad button board (includes bracket and cables)
Before removing the TouchPad button board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
To remove the TouchPad button board:
1.
Position the top cover upside down.
2.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the TouchPad button board and bracket to
the top cover.
3.
Remove the bracket (2).
4.
Release the ZIF connector to the TouchPad board cable (3), and then disconnect the cable from the
TouchPad board. (The TouchPad board is attached to the top cover and cannot be removed.)
ENWW
Battery on page
36), and then remove the following components:
Hard drive on page
49)
Keyboard on page
54)
Top cover on page
57)
Spare part number
689688-001
WLAN module on page
45)
Component replacement procedures
63
Advertisement
Table of Contents
