Table of Contents
Advertisement
Power button board
Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
To remove the power button board:
1.
Position the top cover upright.
2.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the power button board to the top cover.
3.
Remove the power button board (2) while pulling the cable through the hole in the top cover (3).
ENWW
Battery on page
36), and then remove the following components:
Hard drive on page
49)
Keyboard on page
54)
Top cover on page
57)
Spare part number
689686-001
WLAN module on page
45)
Component replacement procedures
61
Advertisement
Table of Contents
