3.
Remove the audio jack (3) from the computer.
To install the audio jack, reverse this procedure.
Connector board cable
To remove the connector board cable, use this procedure and illustration.
NOTE:
The connector board cable is included in the Cable Kit, spare part number N09040-001.
Before removing the connector board cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the connector board cable:
1.
Release the ZIF connector (1) the connector board cable is connected to, and then disconnect the
cable from the system board.
2.
Release the ZIF connector (2) the connector board cable is connected to, and then disconnect the
cable from the connector board.
Preparation for disassembly on page
Bottom cover on page
38).
Battery on page
40).
Connector board cable
38).
51