Speakers - HP EliteBook 1040 Maintenance And Service Manual

3. If the WLAN module antenna is not connected to the terminal on the WLAN module, install a
protective sleeve on the antenna connector, as shown in the following illustration.
To install the WLAN module, reverse the removal procedures.

Speakers

To remove the speakers, use this procedure and illustration.
Table 5-5 Speakers description and part number
Description
Speakers (include cables, left and right speakers, and 4 rubber isolators)
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the speakers:
1. Disconnect the speaker cables (1) from the system board connectors.
2. Remove the four Phillips M2.0 × 2.4 broad head screws (2) that secure the speakers to the computer.
3. Remove the speakers from the computer (3).
When removing the speakers, make note of the location of the four rubber isolator locations (4). The
absence of or damage to these isolators can result in degraded speaker performance.
Preparation for disassembly on page
Bottom cover on page 38).
Spare part number
N15439-001
Battery on page 40).
38).
Speakers 45