Chapter 5: Setting Up Communication With The Monitoring Platform; Communication Options - SolarEdge SE K Series Installation Manual

Chapter 5: Setting Up Communication with the
Monitoring Platform
The inverter sends the following information to the monitoring platform:
Power Optimizer information received via the DC power lines (the PV output circuit)
Inverter information
Information of any other connected devices
This chapter describes how to set up communication between:
The inverter and the monitoring platform through the Internet (wired/ wireless)
Multiple inverters for a leader-follower configuration
Communication setup is not required for power harvesting, however it is needed for
using the monitoring platform.
CAUTION!
ATTENTION!
Lors de la connexion des câbles de communication, assurez-vous que
l'interrupteur MARCHE/ARRÊT à la base de l'onduleur soit en position ARRÊT,
le sectionneur DC est éteint et le CA est en position ARRÊT. Lors de la
configuration des paramètres de communication, assurez-vous que
l'interrupteur MARCHE/ARRÊT soit en position ARRÊT, et le CA est en position
MARCHE.

Communication Options

The following types of communication can be used to transfer the monitored
information from the inverter to the monitoring platform.
NOTE
This guide refers to 3rd party communication products, such as internet
switches and routers that are not supported by SolarEdge. For detailed
information on how to install and use the products, refer to the respective
publication provided with each product.
Ethernet
Ethernet is used for a LAN connection. For connection instructions refer to "Creating an
Ethernet (LAN) Connection" on page 1.
Three Phase Inverters with Synergy Technology PN: SExxK-xxxxIxxxx
Chapter 5: Setting Up Communication with the Monitoring Platform 61