CAUTION!
When removing the cover, make sure not to damage internal components.
SolarEdge will not be held responsible for any components damaged as a
result of incautious cover removal.
ATTENTION!
Lors du retrait du couvercle, assurez-vous de ne pas endommager les
composants internes. SolarEdge ne peut être tenue pour responsable des
composants endommagés à la suite d'une imprudence dans le retrait du
couvercle.
3. Insert the conduit with the AC lines and PE wire through AC opening at the bottom
of the Synergy Manager.
CAUTION!
Ground the conduit nut if required by regulation.
Mettez à la terre l'écrou du conduit si la réglementation l'exige.
NOTE
Connect the equipment grounding before connecting the AC wires to the
AC terminal block.
Veillez à relier le conducteur de PE (la terre) avant de connecter les fils CA
au bornier CA.
4. Strip 0.4 to 0.43" / 10 to 11 mm of insulation from the PE wire.
5. Connect the PE wire to the PE terminal and fasten the Allen screw to a torque of 3.7
lb.*ft for wires of 10 to 4 AWG or 5.9 lb.*ft for wires of 3 to 1/0 AWG.
NOTE
Before connecting lugs to aluminum wires:
a. Remove oxide from the exposed wires with emery paper or a steel-
wire brush
b. Clean dust with a cloth and Isopropyl alcohol (IPA)
c. Coat wires with a designated antioxidant aluminum wire grease
immediately after cleaning
NOTE
Use ferrule when connecting a fine stranded wire.
Three Phase Inverters with Synergy Technology PN: SExxK-xxxxIxxxx
Chapter 4: Connecting PV Modules and AC to the Synergy
Manager 57