Table of Contents
Advertisement
TouchPad button board
Description
TouchPad button board (includes bracket)
Before removing the TouchPad button board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
7.
Remove the system board (see
To remove the TouchPad button board:
1.
Disconnect the cable from the system board (1).
2.
Remove the three Phillips PM2.5×3.5 screws (2) that secure the TouchPad button board to the
computer.
3.
Remove the TouchPad and cable (3).
Reverse this procedure to install the TouchPad button board and cables.
Battery on page
28).
Optical drive on page
Bottom cover on page
System board on page
29), if installed.
32).
53).
Component replacement procedures
Spare part number
813517-001
57
Advertisement
Table of Contents
