Table of Contents
Advertisement
USB board
Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
To remove the USB board:
1.
Disconnect the USB board cable from the system board (1).
2.
Remove the Phillips PM2.5×3.0 screw (2) that secures the USB board to the computer.
3.
Lift the USB board (3) from the computer.
4.
Lift the cable to disengage the adhesive that secures it to the computer (4).
Reverse this procedure to install the USB board.
Battery on page
28).
Optical drive on page
Bottom cover on page
29), if installed.
32).
Component replacement procedures
Spare part number
813515-001
43
Advertisement
Table of Contents
