Table of Contents
Advertisement
3.
Disconnect the battery cable from the system board (see
Remove the display panel:
1.
Open the computer to 90° (1).
2.
Place suction cups in the middle on both sides of the top of the display (2).
NOTE:
3.
While pulling the suction cups away from each other, use a tool to separate the display enough to get to
the tape (3).
NOTE:
4.
On the left and right sides of the panel, grasp the tape with tweezers and roll the tweezers while pulling
the tape out from behind the panel (4).
5.
Rotate the panel over and place it on the keyboard (5).
6.
Peel the tape off the connector on the back of the display panel (1).
26
Chapter 5 Removal and replacement procedures for authorized service provider parts
Be sure not to place the suction cups on the camera module.
Be sure not to place the tool on the camera module.
Battery on page
28).
Advertisement
Table of Contents
