HP ProBook 450 G10 Maintenance And Service Manual page 72

g. Leave the computer upside down on the table for 20 minutes to allow the adhesive to set.
h. Position the computer upright on a table.
i. Leave the computer upright on the table for 10 minutes to be sure that the panel sits correctly
in the display.
10. To remove the camera module:
■
Use a tool to lift up evenly across the module and peel the module up from the display back
cover (1), and then disconnect the cable or cables from the reverse ZIF connector on the module
(2). The camera module is available as spare part number N05869-001 for HD cameras and
N50613-001 for 5 MP + IR cameras. The microphone module is available as spare part number
N05863-001.
NOTE:
to the module.
An HD camera is shown in the following illustration.
64 Chapter 6 Removal and replacement procedures for authorized service provider parts
For installation, note that the cable routes under the camera module before it connects