Maintenance - Cub Crafters CC11-100 Maintenance Manual

(c) Adjust the aileron such that the trailing edge of the aileron is in-line with the
trailing edge of the flap (see Figure 6.3.6.13).

To raise the trailing edge of an aileron, tighten the turnbuckle at the upper
aileron horn and simultaneously loosen the turnbuckle at the lower horn.

To lower the trailing edge of an aileron, reverse the above procedure.
(d) Ensure that the cable tension is 40 ± 5.
(e) Safety each turnbuckle barrel with 2 wire lock clips making sure the clip ends
are locked in the hole. Alternatively use the single wrap method with .032
stainless safety wire.
(f) Repeat for opposite side. Verify the control stick is neutral when ailerons are
neutral. Verify correct cable tension. Verify that the system operates without
binding.
(g) With the ailerons and stick at neutral. Center the aileron stop plate with the aft
mast. Verify that the mast arm contacts the stop plate when the aileron is at the
extent of its deflection (+18° ± 2° / -18° ± 2°).
9.

MAINTENANCE

No major repair or alterations, as outlined in ASTM F2483, FAR 43, or in this manual are
authorized at this time.
To obtain engineering approvals for any major repairs or alterations, please contact Cub
Crafters at:
Cub Crafters, Inc.
th
1918 South 16 Avenue
Yakima, WA. 98903
Tel: 509-248-9491
support@cubcrafters.com
6.3.6
Page: 14
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Manual number SC10000AMM
Date: 05/08/2023