Rudder; Removal; Installation; Rigging - Cub Crafters CC11-100 Maintenance Manual

5.

RUDDER

(1) REMOVAL

See Section 6.3.5 for rudder removal.

(2) INSTALLATION

See Section 6.3.5 for rudder installation.

(3) RIGGING

(a) Check that the rudder is centered when rudder pedals are in line with each other.
(b) File stops to provide proper rudder travel, ends shall be filed parallel to
contacting surface of rudder horn. Ensure that the rudder can travel through its
full range, left and right.
(c) Adjust rudder travel trailing edge RIGHT to +25º ± 2° as indicated. Be sure not to
flex the rudder while deflecting.
(d) Adjust rudder travel trailing edge LEFT to -25º ± 2° as indicated. Be sure not to
flex the rudder while deflecting.
(e) Make any adjustments at the rear cable attach fitting by placing the clevis screw
through one of the other holes in the fitting. Safety each nut with a cotter pin. The
same hole of the cable fitting must be used on both sides of the aircraft.
(f) Make sure all castellated nuts and clevis pins are secured with cotter pins.
(g) Verify full rudder and brake travel is unrestricted. Verify rudder and brake pedals
cannot contact interior panels or structural tubes by firewall.
Manual number SC10000AMM
Date: 05/08/2023
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Figure 6.3.6.2 Elevator Rigging
6.3.6
Page: 5