Elevator Installation - Cub Crafters CC11-100 Maintenance Manual

(7) ELEVATOR INSTALLATION

(a) Identify which are the left and right elevators. The sewn seams are on the
bottom trailing edge of each.
(b) Install each elevator onto the matching hinges on the stabilizers using clevis pins,
tail wire brackets, with a washer at each end of every pin, and then secure each
with a cotter pin. (Figure 6.3.5.8)
Refer to Figure 6.3.5.9
(c) Connect the elevator horns (8 & 9) to the stabilizer and fuselage, and secure with
the bolt (5), washers (6) and lock nut (7) at the top of the horns.
(d) Attach the lower elevator cable connection (10) on the bottom of the elevator
horns, and secure with the cotter pin (4), through the nut (3) with a washer (2).
Tighten the nut finger tight temporarily.
(e) Repeat on the upper elevator cable connection (10). Torque the nut (7) to 38-43
in. lbs.
(f) Check to verify proper elevator movement and routing of cables.
(g) Safety each turnbuckle barrel with two wire lock clips, making sure that each clip
end is locked in the hole. Alternatively, use the single wrap method with 0.032"
stainless steel safety wire.
(h) Reattach the left hand and right hand tail inspection covers.
6.3.5
Page: 12
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Figure 6.3.5.8 Clevis Pin Installation on Elevator
Manual number SC10000AMM
Date: 05/08/2023