Left Horizontal Stabilizer Installation - Cub Crafters CC11-100 Maintenance Manual

(4) LEFT HORIZONTAL STABILIZER INSTALLATION

(a) Apply grease (MIL-G-81322E
stabilizer and install it onto the ends of the tubes that protrude from the side of
the fuselage. It may be necessary to have a second person hold the left stabilizer
as a back up.
(b) Make sure the sewn seams on the trailing edge of both stabilizers are on the
bottom.
(c) Make sure the stabilizer frame fits tightly against the fuselage attachments.
(d) If the tail surfaces have been changed and new tube liners are installed
complete the following;
 Have a second person pull the front corners of the stabilizer together tight
against the fuselage attachment yoke then drill a hole down through predrilled
hole in top of both front stabilizer tubes into the tube liner with a #12 bit.
Drill the holes up from the bottom through the stabilizer and liners and on up

through the top to "clean out" the holes.
(e) Attach with a long bolt (1) and washer (3) inserted down through the stabilizer
and tube (6) and secure it with a washer (4) and nut (5). Torque the nut to 38-43
in. lbs.
(f) Pump grease (MIL-G-81322E
equipped) until it starts to squeeze out.
Manual number SC10000AMM
Date: 05/08/2023
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
to the inside of the front and rear tubes of the right
)
DO NOT DRILL CLEAR THROUGH.
into the stabilizer link assembly grease fittings (if
)
6.3.5
Page: 9