Algo 8410 User Manual page 66

Sync End Time
If set, the device will sync at a random time in the window between Start Time and End Time. Setting an End Time
earlier than the Start Time indicates an overnight period. Leave blank to sync at Start Time exactly.
Sync Frequency
Choose the frequency for which this setting should occur. Select between daily or go to 'Sync Days' to choose specific
days of the week.
Sync Days
Select the days of the week to apply this setting for.
MD5 Checksum
In addition to the .conf file, an .md5 checksum file must also be uploaded to the Provisioning server (for TFTP mode
only). This checksum file is used to verify that the .conf file is transferred correctly without error.
A tool such as can be found at the website address below and may be used to generate this file:
http://www.fourmilab.ch/md5
The application doesn't need an installation. To use the tool, simply unzip and run the application (md5) from a
command prompt. The proper .md5 file will be generated in the same directory.
If using the above tool, be sure to use the "-l" parameter to generate lower case letters.
Generating a generic configuration file
If using a generic configuration file, extensions and credentials have to be entered manually once the 8410/8420 has
automatically downloaded the configuration file.
To see Algo's SIP endpoint provisioning guide, visit:
Generating a Specific Configuration File
The specific configuration file will only be downloaded by the 8410/8420 with the MAC address specified in the
configuration file name. Since all the necessary settings can be included in this file, the 8410/8420 will be ready to
work immediately after the configuration file is downloaded. The MAC address of each 8410/8420 can be found on
the back label of the unit.
To see Algo's SIP endpoint provisioning guide, visit:
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
www.algosolutions.com/provision
www.algosolutions.com/provision
support@algosolutions.com
8410 IP Display Speaker &
Page 65