Table of Contents
Advertisement
Wiring Fault Supervision Mode
Short circuit detection will be triggered when the current draw is <4 mA. Short circuit detection will trigger when the
current draw is >36 mA. The nominal source voltage on the Relay Input circuit is 13 V, with 40 mA current limit.
Action
"Play Tone" will play a recorded audio file to a local speaker and multicast if configured. "Stream Mic Audio" will
stream microphone audio to multicast only, so it requires multicast "Transmitter" mode to be enabled in Basic
Settings → Multicast.
Note
This action will occur 5 seconds after a wiring fault is detected. If the fault is resolved within 5 seconds, this
action will not occur.
•
Play Tone
•
Make SIP Voice Call
•
Make SIP Call with Tone
Tone/Pre-recorded Announcement (Action – Play Tone / Make SIP call with Tone)
Select a recording or tone to use. Custom audio files may be used and uploaded though System → File Manager.
Extension to Dial (Action – Make SIP Voice Call)
SIP account required in Page Extension fields in order to make a call. Can be configured if 'Make SIP Voice Call' or
'Make SIP Call with Tone' actions are enabled under 'Call Button Settings'.
Interval Between Tones (Action –Make SIP call with Tone)
Specify the time delay (seconds) between tones. Can be configured if 'Play Tone' or 'Make SIP Call with Tone' actions
are enabled under 'Call Button Settings'.
Maximum Tone Duration (Action – Play Tone / Make SIP call with Tone)
Select the maximum tone duration. The tone will be terminated once the maximum time is reached. Can be
configured if 'Play Tone' or 'Make SIP Call with Tone' actions are enabled.
Tone Multicast Settings
Use Separate Multicast
This allows the tone to be played via multicast even if the 8410/8420 is configured as receiver. See additional options
when enabled.
•
Multicast Mode
•
IP Address
•
Port
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
support@algosolutions.com
8410 IP Display Speaker &
Page 44
Advertisement
Table of Contents
