Figure 9: 1204 Volume Control - Algo 8410 User Manual

1204 Volume Control
The 1204 Volume Control Switch is a simple two
terminal potentiometer that will allow attenuation
below the maximum volume level (configured under
Basic Settings → Features).
Mute On Lowest Setting
Enabling 'Mute On Lowest Setting' allows audio to be completely muted when volume control switch is turned all the
way down.
Wire Length
This allows you to calibrate impedance for 24 AWG.
Multicast Override
Multicast Override allows selected multicast zones to override the 1204 Volume Control settings for the selected
zones.
Remote Volume Settings
Configure the device to subscribe to remote 1204 volume input or to notify remote devices of 1204 volume input.
Note
RESTful API must be enabled in the Advanced Settings → Admin tab.
Notify (Local 1204) → remote device RESTful API password
Subscribe (Remote 1204)
•
IP address
•
Remote device RESTful API password
Action When Input Triggered
Action
Play Tone
When the 8410/8420 input is triggered, a tone or a pre-recorded audio file will play over the speaker or multicast if
enabled. This function can be used to request support/assistance in service or retail environments, notify about an
emergency at a specific location in medical or educational facilities, or sound an alarm during an intrusion.
•
Action When Input Triggered:
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker

Figure 9: 1204 Volume Control

support@algosolutions.com
8410 IP Display Speaker &
Page 42