Table of Contents
Advertisement
Multicast Type – Polycom Group Paging/Push-to-Talk
The 8410 or 8420 may receive multicast paging compatible with Polycom "on premise group paging" protocol.
To configure the 8410 or 8420 as a Receiver to play Polycom page announcements, select 'Group Page' or 'Push-to-
Talk'. Then enter the Polycom Zone (IP Address and Port) that matches the configuration of the Polycom phones and
Channels. The 'Default Channel' is the target group in a Polycom paging environment.
The Polycom phone used as page audio source for the 8410 or 8420 must be configured to use either the G.711 or
G.722 audio codec. The Polycom phone(s) must also be configured with the "Compatibility" setting
("ptt.compatibilityMode") disabled in order for this codec setting to be applied.
If using a Polycom phone as the Multicast Transmitter, a tone may be set for any of the 25 Polycom Groups configured
on the Algo device. If an Algo device is used as a Multicast Transmitter, a tone does not have to be set as the Algo
Transmitter will provide its own tone. Polycom Group Tones can be set in Advanced Settings → Advanced Multicast.
Receiver (Listener) Zone Settings
Basic Receiver Zones
Select one or more multicast zones for the 8410 or 8420 to subscribe to.
Note
Multicast zone priority is based on the zone definition list order (from top to bottom) in Advanced Settings
Advanced Multicast.
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
support@algosolutions.com
8410 IP Display Speaker &
→
Page 34
Advertisement
Table of Contents
