Table of Contents
Advertisement
Zone Selection Tone
Only visible when "Zone Selection Mode" is set to 'DTMF Selectable Zone'. The tone played over the phone to prompt
the user to select a zone to multicast to.
Transmitter Single Zone
The zone that multicast stream will be sent to by default. If 'DTMF Selectable Zone' is chosen above, this setting will
not apply to Paging, since the zone now must be dynamically selected per call via DTMF. However, the specified
Transmitter 'Single Zone' setting is still used for any multicast events triggered by the Ring, analog input, or the relay
input.
Note
The Transmitter Single Zone is the default zone used for any multicast actions unless an option is created for a
custom zone with specific parameters.
Speaker Playback Zones
The Speaker Playback Zones allows the Transmitter device to play audio for selected zones only. This is useful if using
the DTMF Selectable Zone mode (or More Page Extensions per zone) with the intention of making the Transmitter unit
a member of only certain zones. In this case, the Transmitter does not participate in the Zone, but it transmits certain
traffic.
Expanded Speaker Playback Zones
Up to 50 zones can be shown and are only visible when 'Basic and Expanded Zones' is selected.
DTMF Settings
Zone Selection Tone
This is the prompt to select a zone. This may be used as an interactive voice response (IVR) menu by uploading a
custom audio file through System → File Manager in the Tones folder. Each zone may use a different tone. This can be
configured in Advanced Settings → Advanced Multicast.
Two Digit Selection
When enabled, all DTMF Selectable Zones will require two digits. As a result, Basic Zones must be prefixed with '0' and
Expanded Zones will no longer need to be prefixed with '*'.
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
support@algosolutions.com
8410 IP Display Speaker &
Page 32
Advertisement
Table of Contents
