Table of Contents
Advertisement
Select 'Regular' if solely multicasting to Algo SIP endpoints and/or multicast-enabled phones.
To multicast page announcements solely to Polycom phones, select 'Polycom Group Page' or 'Push-to-Talk'. Then,
configure the 8410 or 8420 with the 'Polycom Zone' (IP Address and Port) and 'Polycom Default Channel'.
Note
Always ensure that the multicast settings on all Receiver devices match those of the Transmitter
Select 'Regular RTP + Polycom Group Page/Push-to-Talk' to multicast page audio to both Polycom phones, Algo SIP
endpoints, and multicast-enabled phones.
Number of Zones
Select 'Basic Zones Only' if configuring nine or fewer multicast zones (shown beside 'Speaker Playback Zones') or
select 'Basic and Expanded Zones' to configure up to 50 zones. The expanded zones have the same behavior as the
basic Receiver zones but are hidden by default to simplify the interface.
Transmitter (Sender) Zone Settings
Polycom Group Selection Mode
'Single Zone' always broadcasts on one pre-configured Polycom Group. In 'DTMF Selectable Zone' mode, the group is
determined by the DTMF selection between 1 – 50.
Zone Selection Mode
"Single Zone" mode always broadcasts on one IP address.
Note
Multiple SIP extensions can be registered on the Transmitter device. Each extension is mapped to a unique zone,
allowing zones to be called directly (e.g., from speed-dial keys). See Additional Features
Extensions.
'DTMF Selectable Zone' mode, offers dynamic zone selection and requires only the Transmitter device to have a
registered SIP Extension. The zone definitions can be found in the Advanced Settings → Advanced Multicast tab.
In 'DTMF Selectable Mode', to page, dial the SIP extension of the Transmitter device: ####, then dial the desired DTMF
page zone (e.g., 1, 2, etc.) on the keypad when prompted.
1. Press DTMF Extension 9 for Priority Call
2. Press DTMF Extension 0 (or 8) for All Call
3. Press DTMF Extension 1 for Zone 1
4. Press DTMF Extension *10 for Zone 10
5. Press DTMF Extension *11 for Zone 11
Note
DTMF codes for zones 10 and higher start with an "*"
All DTMF codes and respective zones are available in Advanced Settings
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
→
support@algosolutions.com
8410 IP Display Speaker &
→
More Page
Advanced Multicast.
Page 31
Advertisement
Table of Contents
