Figure 3: 8410 Basic Settings Features - Algo 8410 User Manual

Ip display speaker, ip dual-sided display speaker
Table of Contents

Advertisement

Inbound Ring Settings
Ring settings apply to events triggered by Ring Extensions and Emergency Alerts.
Ring/Alert Tone
Select an audio file to play when a ring event is detected on the SIP Ring Extension. The audio file may be played
immediately to an associated speaker from the web interface for test purposes using the Play, Loop, and Stop buttons.
During multicast, the device will broadcast an audio stream using the Sender's selected ring tone.
Note
This is the "Default" tone that will be played if selected for Multicast, Additional Ring Extension settings.
Ring/Alert Screen Pattern
Select a screen pattern to display on the LCD screen on inbound ring events. Screen patterns are configured under
Display → Screens.
Ring/Alert Volume
Set the speaker volume for a SIP Ring event. This setting is an amplifier gain control, and the output level will depend
on the levels recorded into the source audio file played from memory. This setting is only used for local tones, and not
when receiving multicast (see Page Speaker Volume below).
Ring Limit
Typically set to no limit, this feature can be used to set a limit on how long the speaker will ring before timing out. A
new ring event is required before the speaker will play the audio file again.
Inbound Page Settings
Page Speaker Volume
This is the Page Speaker Volume control for SIP or multicast paging. This is an amplifier gain control and the output
level will depend on streaming level. This setting will apply to all inbound multicast streams (for Receiver mode only),
regardless of content.
Page Mode
A call to the SIP page extension can be one-way, two-way (using an external microphone), or delayed. In delay mode,
the speaker will store the page into memory and then play after disconnecting.
Delayed Page
Delayed Page allows for a user to record a message before it is played over the speakers. To cancel a page while in
delay mode, press "*" to while the recording state is in process to prevent it from being sent after hanging up.
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
Figure 3: 8410 Basic Settings
Features
support@algosolutions.com
8410 IP Display Speaker &
Page 26

Advertisement

Table of Contents
loading

Table of Contents