Table of Contents
Advertisement
4
FEATURES
4.1
Setting Up Visual Display Content
The display on the 8410 is completely customizable. To set up the display screen:
1. Go to Basic Settings → Screen.
2. Under Default Screen, choose the following screen settings:
a.
Number of Images
b. Images
c.
Text Behavior
d. Text
e.
Text Font
f.
Text Position
g.
Text Color
h. Text Size
i.
Strobe Flash Pattern
To set the idle screen:
1. Go to Basic Settings → Features.
2. Under the Screen heading, select an Idle Pattern and choose the Screen Brightness.
4.2
SIP Paging: One 8410
The 8410 IP Display Speaker can be registered as a third-party SIP extension with a hosted or enterprise
Communications Server supporting 3
To register the 8410 with the SIP server, use the Basic Settings → SIP tab in the web interface to enter the
Communication Server IP address, extension, username, and password. This information will be available from the IT
Administrator.
If VLAN is used, navigate to the Advanced Settings → Network tab to set VLAN options.
Important
Once the 8410 IP Display Speaker is using a VLAN, you will need to be on the same VLAN to access the web
interface.
The Display Speaker may now be accessed by dialing its assigned extension from a telephone, device, or client. The
adapter will auto-answer, play the default pre-announce tone, and allow voice paging until disconnected.
There are several configurable adapter options, such as:
•
Increase or Decrease Speaker Volume
•
Enable AGC (automatic gain control)
•
Enable Ambient Noise Monitoring (speaker volume adapts to background noise)
•
Enable Talkback
•
Customize pre-announce tone file
AL061-UG-GP258410-001-R0
rd
-party SIP endpoints.
support@algosolutions.com
8410 IP Display Speaker &
8420 IP Dual-Sided Display Speaker
Page 14
Advertisement
Table of Contents
