Table of Contents
Advertisement
2. Enter a Name and select Digital Clock. Customize your clock preferences. Press Save.
3. Go to Display → Screens to apply a screen display.
4. Under Default Screen, select the name of the display created in the previous step from the Slides dropdown
menu.
5. Press Save at the bottom right of the page.
2.4
Power Requirements
For optimal performance, Algo recommends using an 802.3bt Type 3 (PoE++) switch for the 8410 and 802.3bt Type 4
(PoE++) switch for the 8420. The minimum power required for the 8410 is 802.3at (PoE+) power and the minimum
power required for the 8420 is 802.3bt Type 3 power. If optimal switches are not available, a power injector may be
used. If using a power injector that does not automatically negotiate its power capabilities, go to Advanced Settings →
Admin to manually configure Automatic Power Detection versus Forced PoE++ mode. off.
2.5
Reset
A recessed reset button (RST) is located at the bottom of the device below the speaker and can only be used to reset
the 8410 IP Display Speaker and 8420 IP Dual-Sided Display Speaker at time of power up. To return all the settings to
the factory default for the 8410, reboot or power cycle the 8410/8420. Wait until the SIP LED flashes and then press
and hold the reset button until the single blue LED on the bottom of the device begins a double flash pattern. Release
the reset button and allow the unit to complete its boot process.
Important
Do not press the reset button until the blue SIP LED begins flashing.
A reset will set all configuration options to factory default including the login password.
Once booting has completed, pressing the reset button will cause the device to speak its IP address over the speakers.
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
support@algosolutions.com
8410 IP Display Speaker &
Page 12
Advertisement
Table of Contents
