Table of Contents
Advertisement
2.2
8420 Mounting & Installation
Algo's 8420 IP Dual-Sided Display Speaker is a two-sided SIP-compliant notification device that can be mounted on the
ceiling or wall for two-sided visual communication. This is ideally suited for hallways, corridors, or open spaces.
What is Included
The following items are included with the purchase of this
device:
•
8420 IP Display Speaker
•
Mounting Bracket
•
Mounting screws to attach device to mounting
bracket (6x 10-32 screws, 2x 10-32 flat head screws
Hex Drive Machine Screws)
•
Terminal Block Plug
•
1/8" Drive Size Allen Key
•
Getting Started Sheet
•
Snap-On Ferrite for Ethernet Cable
2.2.1 Getting Started – Quick Install & Test
1. Connect the 8420 to an IEEE 802.3at / 802.3bt compliant PoE+ or PoE++ network switch or power Injector. See
section 2.4 Power Requirements.
o
The green LED flashers will activate and a small blue light on the bottom below the flasher will remain on
until boot up is completed – about 30 seconds.
o
After a few moments, the screens on either side will show the Algo logo.
2. Attach the snap-on ferrite to the ethernet cable close to the connector to meet FCC requirements.
3. Once the unit finishes booting, a configuration message with the IP address will appear on each screen if it is in
factory default state. If there is no DHCP server, the 8420 will default to the static IP address 192.168.1.111.
Note
If the IP address does not appear on the screen, press the reset (RST) button to hear the IP address recited over
the speakers. The IP address will be repeated over the speakers until the reset button is turned off.
4. Access the 8420 IP Dual-Sided Display Speaker web interface by entering the IP address into a browser and login
using the default password algo.
2.2.2 Installation
The 8420 IP Dual-Sided Display Speaker is designed to be both ceiling and wall mounted. Wiring enters through an
opening in the hollow bracket for this product (see info in the Note after bullet 1 below).
Mounting the bracket securely to the wall/ceiling:
1. Mount the bracket securely to a wall or ceiling. Because the material you mount the device into may differ, see
below for specific wall or ceiling mount instructions by material type.
Note: Wires can be routed into the hollow tubes of the bracket from the wall/ceiling or through the wire feed hole outside the
tube. Wire must be routed on the same side as the speakers to match the connection area.
AL061-UG-GP258410-001-R0
8420 IP Dual-Sided Display Speaker
What is Not Included
The following items are not included with the purchase of this
device:
•
Ethernet Cable
•
PoE++ Switch
•
Mounting screws to attach mounting bracket to wall
or ceiling (recommended mounting hardware
outlined in this guide)
support@algosolutions.com
8410 IP Display Speaker &
Page 10
Advertisement
Table of Contents
