Immergas MAGIS M4-30 Use And Installation page 9

AVVERTENZA
by su ocation if they play with plastic bags.
• Safely dispose of packaging materials such as nails or other metal or wooden parts which could cause injury.
• Ask your dealer or quali ed personnel to perform the installation jobs in compliance with this manual. Do not install
the unit on your own. Improper installation could cause water leaks, electric shocks or re.
• Make sure to use only the accessories and components speci ed for the installation jobs. Failure to use the speci ed
components could cause water leaks, electric shocks, re or cause the unit to fall o its stand.
• Install the unit on a foundation capable of bearing its weight.
stable.
• Perform the speci ed installation jobs taking into account strong winds, hurricanes or earthquakes. Improper instal-
lation could cause accidents due to the equipment falling.
• Make sure that all the electrical jobs are carried out by quali ed personnel in compliance with local laws and regulations
and with this manual, using a separate circuit. An insu cient capacity of the power circuit or an incorrect electrical
system can cause electrical shocks and re.
• Make sure to install a ground fault circuit interrupter in compliance with local laws and regulations. Failure to install
a ground fault circuit interrupter can cause electrical shocks and re.
• Check that all the cables are rm. Use the speci ed wires and check that the connections of the terminals or wires
are protected against water and other outside adverse forces. An incomplete connection or fastening can cause a re.
• When wiring the power supply, position the wires so that the front panel can be xed safely. If the front panel is not
in place, there could be overheating of terminals, electric shocks or re.
• A er having completed installation, make sure there are no refrigerant leaks.
• Never touch leaking refrigerant as it could cause frostbite. Do not touch the refrigerant pipes during and immediately
a er operation as the refrigerant inside could be hot or cold, depending on the conditions of the refrigerant owing
through the pipes, the compressor or the other parts of the refrigerant cycle. Touching the refrigerant pipes could cause
burns or frostbite. To avoid injury, allow the pipes to return to normal temperature or, if you need to touch them, put
on protective gloves.
• Do not touch the internal parts (pump, etc.) during and immediately a er operation. Contact with internal parts
can cause burns. To avoid injury, allow the internal components to return to normal temperature; otherwise, if you
absolutely need to touch them, put on protective gloves.
CAUTION
laced the unit on the ground.
• e earthing resistance must comply with local laws and regulations.
• Do not connect the earth cable to gas or water pipelines, to lightning rods or the earth cables of the telephone.
• Incomplete earthing can cause electric shocks.
- Gas pipes: gas leaks could cause a re or explosion.
- Water pipes: rigid rubber hoses do not guarantee earthing.
- Lightning rods: or telephone earthing wires: the electrical threshold could increase anomalously if struck by lightning.
• Install the power cable at least 1 m away from TVs and radios to avoid interference or noise. (Depending on the radio
waves, a distance of 1 m might not be enough to eliminate noise).
• Do not use pressurised water without a large di user. Do not use high-pressure cleaners for Cu/Cu and Cu/Al air
coils. Concentrated and/or rotating water jets are strictly prohibited. Never use uid with a temperature above 45°C
to clean the air heat exchangers.
the power cable is damaged, it must be replaced by the manufacturer, by a service agent or by just as quali ed persons
to avoid danger.
e device must be installed in compliance with the national wiring regulations. If
e appliance could fall or cause injury if not su ciently