Immergas MAGIS M4-30 Use And Installation page 79

1 Signal cable of the solar energy kit
2 Control panel cable
3 Room thermostat cable
5 Probe cable for Tw2
9 Domestic hot water pump control cable
10/11/23 3-way valve control cable
12 Probe cable for T5
13 Booster heater control cable
15 Unit power cable
(a): Minimum cable cross-section AWG18 (0.75 mm
(b): e thermistor and the connection cable (10 m) are delivered with the domestic hot water tank (T5) or with the zone
2 outlet temperature probe (Tw2).
(c): Chap. 9.7.4 Speci cations of standard wiring components.
NOTE
and the user interface cable.
e instruments must be earthed.
• All external high-voltage loads, if in metal or with earthing connection, must be earthed.
• All external load currents must be lower than 0.2A, if the single load current is higher than 0.2A, the load must be con-
trolled by an AC contactor.
• e ports of the wiring terminals R1, R2, and DFT1, DFT2 only supply a signal switch. Please refer to Chap. 9.7.6 To
obtain the position of the ports in the unit.
Description
1
2
3
1 Hole for high-voltage wire
2 Hole for low-voltage wire
3 Hole for high-voltage or low-voltage cable
4 Water outlet
5 Water inlet
6 Drain outlet
7 Drain pipe hole (for safety valve)
Number of conductors
AC/DC
required
AC
AC
AC 2 or 3
DC
AC
AC 2 or 3
DC
AC
AC 3+GND
2
)
4
5
6 7
Assembly unit
Maximum operating
2 200 mA
5 200 mA
200 mA (a)
2 (b)
2 200 mA (a)
200 mA (a)
2 (b)
2 200 mA (a)
(c)
current