Immergas MAGIS M4-30 Use And Installation page 28

Installation of rear cover.
Posizione di chiusura
Cacciavite
screwdriver
a taglio
Foro vite presente per
M4X20
tre M4X20
1) Insert a at-headed screwdriver at the closing point at the bottom of the control panel and rotate the screwdriver to
remove the rear cover (be careful not to damage it).
2) Use three M4X20 screws to directly mount the rear cover on the wall.
3) Use two M4X25 screws to install the rear cover on the junction box 86 and use a M4X20 screw to x it to the wall.
4) When inserting the screw plug in the wall, make sure it is ush with the wall.
5) Use the Phillips screws to x the bottom cover of the control panel into the wall using the screw plug. Make sure that the
bottom cover of the control panel is at the same height a er installation, then reposition the control panel on the bottom cover.
6) Do not overtighten the screw to prevent it from deforming the rear cover.
Coperchio posteriore
Coperchio
anteriore
A
Intaglio foro uscita fili
slit
lato inferiore sinistro
B
Foro
60mm
hole
cablaggio
Foro vite presente per
M4X20
tre M4X20
Foro vite presente su
scatola di derivazione 86,
86, use two M4X25mm
utilizzare due M4X25mm
Foro uscita
fili lato
inferiore
side wires
outlet hole sinistro
C
Foro parete e foro cablaggio
Diameter: Ø8 - Ø10
Diametro: Ø8 - Ø10
Coperchio
posteriore
Fili
cablaggio