Immergas MAGIS M4-30 Use And Installation page 19

Block heat pumps
Hide thumbs Also See for MAGIS M4-30:
Table of Contents

Advertisement

will do).
Turn the outlet side of the air towards the wall of the building, fence or screen.
Make sure there is su cient space for installation.
Arrange the outlet side at a right angle with respect to the wind direction.
repare a water discharge channel around the foundation, to drain the water around the unit.
• If the water has di culty owing out of the unit, mount the unit on a cement block foundation, etc. (approximately 100
mm (3.93 in) high).
• If the unit is installed on a frame, assemble a waterproof plate (about 100 mm) on the lower side of the unit to prevent
the water from entering from below.
• When the unit is installed in a place frequently exposed to snow, please pay particular attention to raise the foundation
as high as possible.
Under normal conditions, refer to the following gures for installation of the units 18-30 kW:
4-6 kW
8-16 kW
B
≥ 1000 mm
≥ 1500 mm

Advertisement

Table of Contents
loading

Table of Contents