Test Mode And Nal Checks; Final Checks; Test Operation Manual - Immergas MAGIS M4-30 Use And Installation

Code
number
ADDRESS
16.3
RESET
17.1 HMI SET
HMI ADDRESS
17.2
FOR BMS
17,3 STOP BIT
11
TEST MODE AND FINAL CHECKS.
e installer must check that the unit works properly a er installation.
11.1

FINAL CHECKS.

Before switching on the appliance, read the following recommendations:
• When installation is complete and all the necessary settings have been made, close all the front panels of the unit and put
the unit cover back on.
• e service panel of the electric switchgear can only be opened by an authorised electrician for maintenance.
NOTE
nameplate. is is caused by the compressor which needs 50 hours of operation before reaching regular operation and
stable energy consumption.

TEST OPERATION MANUAL .

If necessary, the installer can perform a manual test operation at any time to check proper operation of the air purge, heat-
ing, cooling, domestic hot water heating, see Chap. 10.5.11 Test operation.
Status
Reset the address code of the unit.("FF" is an
invalid address code.) A er having set the
address, press"UNLOCK" to con rm.
Select the HMI:
0=MAIN, 1=SEC.
Set the HMI address code for BMS
Set the stop bit value
Mini- Maxi-
Default
mum mum
FF 0 15
0 0 1
1 1 16
1 1 2
Interval
Unit
de nition
1 /
1 /
1 /
1 /