Immergas MAGIS M4-30 Use And Installation page 111

During execution of the DHW MODE test, the default temperature of the domestic hot water is 55°C.
heater) switches on a er the compressor has been operating for 10 minutes.
heat pump will run until the water temperature increases to a certain value or another command is received.
During execution of the test, only the OK button remains valid. If you want to interrupt the test, press OK. For example,
when the unit is in air purge mode, a er having pressed OK, the following page is displayed:
Press
10.5.12 Special Function.
When in special function mode, the control panel cannot work, it does not go back to the main screen and the screen shows
the page that executes the special function, the control panel does not block.
NOTE
AWAY, HOLIDAY HOME).
>FOR SERVICEMAN>12.SPECIAL FUNCTION.
Before oor heating, if a large amount of water remains on the oor, the oor could deform or even break during the oor
heating operation. In order to protect the oor, it must be dried and the oor temperature must steadily increase.
11 MODALITÀ TEST
Modo test attivo.
Modo ACS attivo.
La temperatura del flusso d'acqua
è di 45°C
La temperatura del serbatoio dell'acqua
è di 30°C
OK CONFERMARE
11 MODALITÀ TEST
Si desidera disattivare la MODO TEST
(SPURGO DELL'ARIA)funzione?
NO
NO
OK CONFERMARE
12 FUNZIONE SPECIALE
"FUNZIONE SPECIALE"?
NO NO
OK CONFERMARE
e TBH will switch o 3 minutes later, the
SÌ
SÌ
e TBH (tank booster