Connecting An External Rsd Switch (Optional) - SolarEdge Energy Bank Installation Manual

38 Connecting an External RSD Switch (Optional)
Figure 15: External CT connection
4. Close the CT gland to a torque of 5.5 N*m.
Connecting an External RSD Switch (Optional)
If required, an external rapid shutdown switch can be installed to shut down the system
in case of emergency.
The switch is not supplied by SolarEdge and should be purchased separately.
If the SolarEdge Backup Interface is installed as part of the system, connect the external
RSD switch to the Backup Interface (see the Backup Interface installation guide). Then,
connect the RSD wires from the Backup Interface to the inverter, in the same manner, as
explained below.
SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5