Connecting The Inverter To Ac Grid; Connecting The Dc Strings To The Inverter - SolarEdge Energy Bank Installation Manual

Connecting the Inverter to AC Grid
For connecting the inverter to AC grid, use a 1–10 mm
For more wiring information, refer to the SolarEdge Recommended AC
Wiring Application Note , available on the SolarEdge website at
http://www.solaredge.com/files/pdfs/application-note-recommended-
wiring.pdf.
To connect to AC grid:
1. Turn off the AC circuit breaker on the distribution panel.
2. Strip 2.5'' / 60 mm of the external cable insulation and strip 0.7'' / 18 mm of the
internal wire insulation.
3. Pass the AC cable through the conduit.
4. Connect the wires to the AC terminals as shown below.

Connecting the DC Strings to the Inverter

Connect the string to the DC input pairs. If required, connect additional strings in
parallel using an external combiner box/branch cables before connecting to the inverter.
When installing a battery, connect the DC cables from the battery and from Power
Optimisers to an external combiner box, compliant with local regulation. Then, connect
the cables from the combiner box to the DC terminals inside the inverter's Connection
SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5
Figure 10: Insulation Stripping – AC Cable
Figure 11: AC connection
Chapter 5: Connecting the
2
cable.
Inverter 33