List Of Installation Equipment - SolarEdge Energy Bank Installation Manual

10 List of Installation Equipment
Supported Batteries
Manufacturer Model
SolarEdge
For the SolarEdge Energy Bank installation guide, see:
https://www.solaredge.com/sites/default/files/se-energy-bank-
installation-guide.pdf
SolarEdge Home Backup Interface (optional, required for backup
support) - controls disconnection of house loads from the grid and integrates the
following components to enable grid-tied solar backup and Smart Energy
Management. The SolarEdge Home Backup Interface must be installed to allow the
operation of the batteries and inverter during backup.
100A microgrid interconnection device - disconnects the house loads from the
grid in case of a power outage.
NOTE
Additional SolarEdge inverters can be connected over RS485. The inverters will
participate in export limitation, Smart Energy Management and backup
operation.
PV modules connected to power optimizers are not mandatory for charge/
discharge profile programming.

List of Installation Equipment

Standard tools can be used during the installation of the SolarEdge system. The
following is a recommendation of the equipment needed for installation:
4 mm Allen torque screwdriver for the inverter enclosure screws
Allen torque screwdriver for M5/M6/M8 screw types
Standard torque flat-head screwdrivers set
Non-contact voltage detector
Cordless drill ( clutch) or screwdriver and bits suitable for the surface on which the
inverter and optimisers will be installed. Use of an impact driver is not allowed.
Mounting hardware (stainless bolts, nuts, and washers) for attaching:
Technical Description
Energy Residential ESS (lithium
Bank ion battery)
SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5
Mark of Conformity
UL 1973 / UL9540 / CE / RCM /
(IEC 62619)