System Manager - Connection To Thermoflue - Immergas System Manager Kit Instructions And Warnings

9.38 SYSTEM MANAGER - CONNECTION TO THERMOFLUE.

Key:
A15-4: - Zone expansion kit with address 4
THERMOFLUE: -On/Off contact from thermoflue.
Note: - Configure the expansion address as indicated.
- Thermoflue: input contact to disable the generators when a thermoflue operates. If
the contact closes Audax, boiler/resistances remain in stand-by.
The manual switching to cooling switch is a normally closed contact which, when
I set the system to cooling, must be open to avoid inhibiting the activation of the
HP in cooling and DHW.
A15-4
2
1 - Power supply 24 Vac - 50 Hz
2 - Fireplace heating system
3 - Function
4 - Expansion Addresses
5 - Special functions 1
6 - Address 4
E/I: - Manual switching to cooling switch
3
5 6
87 87
4
1
9-38