Table of Contents
Advertisement
8.2
BOILER CONFIGURATION.
The connection of boilers to the System Manager can be
made in 4 different ways, which can be set on page X01
depending on the model:
- Connection via Immergas BMS (BMS boiler);
- Connection via ModBus interface (IMGBUS boiler);
Model Name
VICTRIX SUPERIOR PLUS
VICTRIX SUPERIOR
VICTRIX MAIOR TT PLUS
VICTRIX MAIOR TT
VICTRIX KW TT PLUS
VICTRIX KW TT
VICTRIX TT
VICTRIX TERA PLUS V2
VICTRIX TERA PLUS
VICTRIX TERA V2
VICTRIX TERA
VICTRIX TERA VIP
VICTRIX EXA
VICTRIX OMNIA
VICTRIX ZEUS
VICTRIX ZEUS SUPERIOR
HERCULES CONDENSING
HERCULES MINI CONDENSING
ARES CONDENSING 32
VICTRIX PRO
ALL MODELS
With the exception of dry contact thermostats, all tem-
perature control devices used on boilers (remote controls,
wireless room probes, etc.) are not compatible with the
System Manager.
The presence of the boiler is necessary if the high tem-
perature zone is to be enabled.
- Connection via analogue signal (boiler 0-5 V/0-10 V);
- Connection via dry contact (boiler ON/OFF).
The following table shows in which mode Immergas
boilers must be connected and which functions are
supported:
Activation
Connec-
of heating
tion Type
and DHW
mode
BMS
✓
IMGBUS
✓
0-5 V
✓
0-10 V
✓
ON/OFF
✓
If the boiler provides for operation with an independent
domestic circuit (See Parag. 5.6) it is recommended to set
the boiler hysteresis so that its activation in DHW mode
occurs at a higher temperature than the DHW set point
of the heat pump, or to use the DHW thermostat mode
where applicable.
58 58
Remote
Remote set-
setting of
ting of heating
independent
flow set point
or autono-
and climatic
mous DHW
curve
set point
✓
✓
✓
✓
✓
X
✓
X
X
X
Remote
reading of
operating
parame-
ters and
faults
✓
✓
X
X
X
Advertisement
Table of Contents
