Notes For Zone Remote Control - Immergas System Manager Kit Instructions And Warnings

7.2 NOTES FOR ZONE REMOTE
CONTROL
Please refer to the relevant instructions sheet for instal-
lation instructions. The required addresses to use are:
31 = Zone 1
32 = Zone 2
33 = Zone 3
34 = Zone AT
On the zone remote control it is possible to set:
- the operating mode;
- the room set point;
- room humidity set point.
The following can also be displayed:
- zone room temperature;
- relative humidity;
- current DHW set;
- zone flow set;
- generic alarm signal;
- activation of:
- heat pump;
- boiler;
- zone antifreeze;
- zone pump;
- zone dehumidification.
The zone remote control manages the heating/cooling
of the associated zone.
The functions valid for the secondary remote zone con-
trol are enabled with:
- Buttons to the side of the display (Ref. 2 - 3 Fig. 7-2)
allow to select the available functions.
- main switch (Ref. 1 Fig. 7-2) by turning it one can select
the values of the parameters. The parameter being ed-
ited flashes, to store the selected value press the main
selector.
Programming current time and day. Press and hold
the "time band " button until the "
tion appears.
2
Select the function and adjust it according to the current
time and day.
49 49
" func-
Clock
3
1
7-2
7-3