Table of Contents
Advertisement
4
DIAGNOSTICS
AND ERRORS
4.1
DIAGNOSTICS.
The "System Manager Kit" control continually controls
the functioning status of the whole system and signals
any anomalies, stating the corresponding error code on
the display.
In the case of a fault that cannot be reset, contact a
qualified technician (e.g. the After-Sales Technical
Assistance Service).
The alarm code is displayed in the event of an error, with
the symbol
and icon
Press the button
to display the "Alarms log"; this
section displays occurred alarms, not yet reset, from the
most recent to the oldest.
Press arrows
to scroll and display all extant
alarms.
The anomalies displayed in the "System manager kit" are
listed in the "Anomalies list" chapter.
If no alarm has been triggered, it is still possible to view
the "Alarms log" by proceeding as follows:
- press the button
- scroll with buttons
select "06. ALARM LOG".
- Press the
button to enter the menu.
As well as the error codes referring to the functioning
state of the system, the"System Manager Kit" also checks
its own functioning state, indicating any malfunctions.
above the relevant button.
;
the navigation menu and
4.2
RESET ERRORS.
Press the button
the navigation menu.
Press and hold the RES button to display the screen
where it will be possible to reset the alarms and heat
pump log (H02).
Press button
for the option "Reset log" to start
blinking.
Press arrows
to confirm (YES) or cancel (NO)
any reset. At the end, press button
for the option "Reset Audax and boiler alarms" to start
blinking. Proceed in the same manner to reset any pump
and boiler alarms.
At the end press button
main screen.
18 18
to display the "Alarms log" or via
to confirm and
twice to go back to the
Advertisement
Table of Contents
