Table of Contents
Advertisement
• COMFORT SET: it lets you set the DHW set-point in
the COMFORT time range (refer to settings of DHW
time slots) (M03);
• ECO Set: it lets you set the DHW set-point in the ECO
time range (refer to settings of DHW time slots) (M03);
• Temperature: it displays in real time the domestic hot
water temperature (M03).
2.4
DOMESTIC HOT WATER TEMPERATURE
SETTING ON BOILER SIDE.
If the system allows it (independent DHW circuit and
boiler present), it is possible to set a specific boiler set-
point, which is responsible for heating a portion or the
entire storage tank at a specific temperature; this tem-
perature is different from those set in the previous pages.
From the main screen (M01), press arrows
the boiler side domestic hot water temperature figure is
displayed (M04).
Press the
button again to make the first reading
(boiler side water T.) blink.
Set as desired by pressing arrows
press button
to confirm and for the next figure
(DHW Set) to start blinking.
After setting the last figure, when button is pressed
the cursor no longer blinks and it is possible to change
screens with buttons
At the end press button
main screen.
until
. At the end,
.
twice to go back to the
2.5
SETTING COMFORT AND REDUCED
ROOM TEMPERATURE.
It is possible to set two different room temperature levels:
- setpoint COMFORT;
- setpoint ECO.
Press the
button to enter the navigation menu.
Press buttons
POINT".
Press button
to enter the first room set (Summer)
(S02).
Press the
button again to make the first value
(Comfort) to flash.
Set as desired by pressing arrows
press button
to confirm and for the next figure
(Low) to start blinking. Proceed in the same way for this
setting then go to the last setting (Humidity).
When button
is pressed the cursor no longer blinks
and it is possible to change screen with buttons
and set the figures of the next room sets (Summer with
cooling, Winter) for each configured area.
Note: the new settings will be used at the next time
range variation or temporarily setting the system to
stand-by mode.
At the end press button
main screen.
- Party mode (S01). Activating the party mode sets all
zones in "Comfort" mode until the next programmed
status change. The central heating or cooling mode will
depend on the system state.
12 12
until selecting menu "01. SET-
. At the end,
twice to go back to the
Advertisement
Table of Contents
