Anker A8327 - Soundsync Bluetooth Transmitter Manual

Safety Instructions

• Do not drop, knock, or shake the device.
• Do not disassemble. Do not attempt to open the device.
• Keep the device dry and away from all types of liquids or moisture that will corrode the electronic circuits. If the device gets wet, dry it immediately.
• Avoid extreme temperatures.
• Do not use outdoors during thunderstorms.
• Use original or certified cables only.
• Do not use any corrosive cleaner / oil to clean.

The device should be charged at least once a month to preserve battery life.

What's Included

At a Glance

1. Multi-function Button
2. LED Indicator
3. 5 mm AUX Input
4. Micro USB Charging Port
5. Multipoint Connection LED Indicator
6. Volume Down
7. Volume Up

• Charge the Bluetooth Transmitter before first use.
• If Soundsync freezes, press and hold the multi-function button, insert the Micro USB cable to start charging, then restart Soundsync.

LED Indicator Guide

Using Your Device

Turn on / off

Connect to a Bluetooth Device

1. When Soundsync is turned on, press the multifunction button twice to enter Bluetooth pairing mode. The LED indicator will flash red and blue alternately.
2. Enable Bluetooth on your Bluetooth headphones or speaker and pair it with Soundsync. When successfully paired, the LED indicator will turn blue.
3. Connect Soundsync to your device using the provided 3.5 mm audio cable.

Connect to two devices at the same time

1. Follow the steps in the "Connecting Soundsync to a Bluetooth device" section to connect Soundsync to the first Bluetooth headphone or speaker.
2. Press the multifunction button twice to re-enter Bluetooth pairing mode.
3. Enable Bluetooth onthe second Bluetooth headphone or speaker and pair it with Soundsync. When successfully paired, the LED indicator and Multipoint connection LED indicator will turn blue simultaneously.
4. Connect Soundsync to your device using the provided 3.5 mm audio cable.

Now you can listen to music from both Bluetooth headphones or speakers.

If there is still no sound coming from your devices devices, turn off Soundsync and then reconnect two devices. If connection fails again, repeat the steps above.

AUX mode

Soundsync will automatically switch to AUX mode when a 3.5 mm audio cable is plugged in.

Charging Your Device

• Use the included Micro USB cable to charge your Soundsync and make sure it is fully charged before first use.
• When not in use, store your Soundsync in a cool place.

Specifications

Specifications are subject to change without notice.

DC input	5V 0.5A
Battery capacity	180mAh
AUX playtime	12 hours
Charging time	2 hours
Bluetooth version	V5.0
Support format	A2DP AVRCP
Supported codec	aptTMX Low Latency aptTMX SBC
Size	50 × 29 × 10 mm / 2.0 × 1.1 × 0.4 in
Weight (without packaging)	13.5g / 0.5oz
Operating temperature range	14°F to 131°F / -10°C to 55℃
Range	10 m / 33 ft

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Anker A8327 - Soundsync Bluetooth Transmitter Manual