Download
Share
Print this page
Ricoh BK5010 Technical Bulletin
  1. Manuals
  2. Brands
  3. Ricoh Manuals
  4. Booklet makers
  5. BOOKLET MAKER BK5010
  6. Technical bulletin
Ricoh BK5010 Technical Bulletin

Ricoh BK5010 Technical Bulletin

Plockmatic booklet maker
Hide thumbs Also See for BK5010:
1
2
3

Advertisement

Quick Links

Download this manual
Model:
Plockmatic Booklet Maker BK5010 system
Subject:. BF5010 Tilt the Machine Warning
From: PLOCKMATIC
Classification:
SYMPTOM:
If not following each step in the attached update of the service manual page
BF3-6 to BF3-7 when tilting the BF5010 there is a risk of personal injury.
CAUSE:
The Service Manual lacks warnings and procedure is not fully up to date
regarding BF5010 in relation to BF90.
SOLUTION: Warning
Before tilting the BF5010 make sure pivot screws [E] are NOT tightened.
They should be loosened about ½ turn.
When tilting the BF5010, make sure to fasten and tighten BOTH screws
[G], one on each side.
Next Service Manual update will include the updated instruction
attached.
For the full updated procedure, see attached instruction.
T
echnical
Troubleshooting
Mechanical
Paper path
Other
[E]
[G]
B
ulletin
Date: 3-Jul-06
Prepared by: Göran Sandén
Europe/Asia, USA
Part information
Electrical
Transmit/receive
PAGE: 1/3
No.: RZP18 002
Action required
Service manual revision
Retrofit information

Advertisement

loading

Related Manuals for Ricoh BK5010

Summary of Contents for Ricoh BK5010

  • Page 1 PAGE: 1/3 Model: Date: 3-Jul-06 No.: RZP18 002 Plockmatic Booklet Maker BK5010 system Subject:. BF5010 Tilt the Machine Warning Prepared by: Göran Sandén From: PLOCKMATIC Europe/Asia, USA Troubleshooting Part information Action required Classification: Mechanical Electrical Service manual revision...
  • Page 2 Infeed view WARNING Book Folder may Tip. Install Service bracket before separating the Book Folder from the Trimmer. Removal 1. Remove Belt stacker ( Service manual BK5010 3.8.1). 2. Remove the Trim bin. 3. Remove the Service bracket [A] by removing two nuts ( x 2 ). 4. Remove the foot screw [C] and mount it in the oposite hole up-side-down.
  • Page 3 COVERS 3 July 2006 Front view Rear view Front view, Rear view, machine tilted machine tilted 11. Remove screws [F]. One on each side ( x 2). NOTE: Keep the screws. They will be used later in this procedure. CAUTION When lowering or raising the machine, lift in infeed area only.