Tp-Link AC1900 Wireless Dual Band Gigabit Router Quick Guide
Connect the Hardware
If your Internet connection is through an Ethernet cable from the wall instead of through a DSL / Cable / Satellite modem, connect the Ethernet cable directly to the router's Internet port, then follow steps 5 and 6 to complete the hardware connection.
- Install the antennas.
- Turn off the modem, and remove the backup battery if it has one.
- Connect the modem to the Internet port on your router with an Ethernet cable.
- Turn on the modem, and then wait about 2 minutes for it to restart.
- Turn on the router.
- Verify that the following LEDs are on and solid before continuing with the configuration.
Note: If the 2.4G LED and 5G LED are off, please press the WiFi button on the side panel for 2 seconds and check the LEDs again a few seconds later.
Q1. What can I do if the login window does not appear?
- If the computer is set to a static or fixed IP address, change the setting to obtain an IP address automatically.
- Verify if http://tplinkwifi.net or http://192.168.0.1 is correctly entered in the web browser.
Alternatively, enter http://192.168.1.1 in the web browser. - Use another web browser and try again.
- Reboot your router and try again.
- Disable and enable the the network adapter in use again.
Q2. What can I do if I cannot access the Internet?
- Check if the Internet is working properly by connecting a computer directly to the modem via an Ethernet. If it is not, contact your Internet Service Provider.
- Open a web browser, enter http://tplinkwifi.net or http://192.168.0.1 and run the setup again.
- Reboot your router and try again.
- For cable modem users, reboot the modem first. If the problem still exists, log into the Web Management page of the router, and go to Advanced > Network > MAC Clone, click Clone MAC Address and then click Save.
Q3. How do I restore the router to its factory default settings?
- While the router is powered on, press and hold the Reset/WPS button on the back until the blinks.
- Log into the Web Management page of the router, and go to Advanced > System Tools > Factory Defaults, click Restore. The router will restore and reboot automatically.
Q4. What can I do if I forgot my Web Management password?
- Refer to FAQ > Q3 to reset the router, and then use the default admin (all lowercase) for both username and password to log in.
Q5. What can I do if I forgot my wireless network password?
- If you have not changed the default Wireless Password, it can be found on the product label of the router.
- Log into the Web Management page, go to Basic > Wireless to retrieve or reset your wireless password.
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Tp-Link AC1900 Wireless Dual Band Gigabit Router Quick Guide
Need Assistance?
Do you have a question about the Archer C9 that isn't answered in the manual? Leave your question here.