INFORMATION
i
Entering the power consumption parameter is optional.
Parameters not activated in the system are marked "--".
e heat pump capacity is only indicated as a reference and must not be used to assess the e ciency of the unit.
Sensor accuracy is ± 1°C.
e ow rate parameters are calculated based on the operation parameters of the pump.
e deviation changes depending on the ow rates.
e maximum deviation is 15%.
6.9 FOR SERVICEMAN.
6.9.1 Information on For serviceman menu.
e FOR SERVICEMAN menu is intended for the installer and service engineer.
• Setting the functions of the appliance.
• Setting the parameters.
6.9.2 How to access the For serviceman menu.
Go to "
" > "FOR SERVICEMAN". Press "OK".
•
e FOR SERVICEMAN menu is intended for the installer and service engineer. Domestic users must NOT modify the
settings through this menu.
•
is is why it is protected by password to prevent unauthorised persons from having access to the service settings.
•
e password is 234.
6.9.3 How to exit the FOR SERVICEMAN menu.
If all the parameters have been set, press "
Select "YES" and press "OK" to exit the FOR SERVICEMAN menu.
A er you have exited the menu, the unit shuts down.
FOR SERVICEMAN
P ER I L SER V I Z I O
A SSI STEN Z A
I n s e r i r e p a s s w o r d :
Please input password:
2
3
4
ENTER
CO N F ER M A
ADJUST
M O D I F I CA
O K
".
e following page is displayed:
P ER SER V I Z I O
FOR SERVICEMAN
A SSI STEN Z A
Active the setting and exit?
A t t i v a r e l e i m p o s t a z i o n i e u s c i r e ?
N O
YES
N O
SÌ
CO N F ER M A R E
CONFIRM
ADJUST
M O D I F I CA
O K
43